Jilter Filters + 3 XL Glass Tips
Rolling papers
by Jilter
We'll only email you about this product — no marketing.
Jilter Filters + 3 XL Glass Tips
The Jilter Filters + 3 XL Glass Tips kit combines reusable Jilter filters glass tips with cellulose screw-in filters to deliver a noticeably smoother, cooler smoke from your self-rolled cigarettes. Each XL glass tip matches the diameter of a standard cigarette filter — 6mm — so there's no fiddling with oversized or undersized tips. You get 42 Jilter filters and 3 XL glass mouthpieces in one pack, making this one of the most practical filtration kits you can buy for daily rolling.
Why Glass Tips with Jilter Filters Beat Cardboard Roaches
Jilter filters glass tips outperform cardboard roaches because they combine physical tar filtration with a reusable, heat-resistant mouthpiece that never gets soggy. A rolled cardboard roach does one job: stop bits of tobacco hitting your tongue. That's about it. It doesn't filter anything, it gets soggy after a few minutes, and you bin it every time. The Jilter system works differently. The XL glass tip acts as a permanent mouthpiece — rinse it, reuse it, done. The cellulose Jilter filter screws into the tip and actually catches tar and fine particles before they reach your mouth. The result is a draw that feels clean and noticeably cooler on the lips.
We've handled hundreds of glass tips over the years, and the thing that sets these XL versions apart is the diameter. Most glass tips on the market are slim — fine if you roll thin cigarettes, but awkward if you're used to the girth of a factory-made filter. These XL tips sit at 6mm, which is the same as a standard cigarette filter. That means your roll looks and feels like a proper cigarette rather than a cocktail stick with ambitions.
The honest limitation? Glass breaks. These tips are small and sturdy, but drop one on a tile floor and you're down to two. Keep them in the little plastic case they come in, or toss them in a pouch. Treat them like you'd treat a decent lighter — don't leave them rattling loose in your pocket with your keys.
What's Inside the Pack
This kit contains 42 single-use cellulose Jilter filters and 3 reusable XL glass tips, all housed in a compact case that fits in a shirt pocket.
| Spec | Detail |
|---|---|
| Filter count | 42 Jilter cellulose filters |
| Glass tips | 3 XL reusable glass mouthpieces |
| Tip diameter | 6mm (matches standard cigarette filter) |
| Filter material | Cellulose sponge with fine pores |
| Filter attachment | Screw-in (press-fit into glass tip) |
| Reusable component | Glass tips — rinse and reuse |
| Disposable component | Jilter filters — single use |
| SKU | HS0505 |
How Jilter Filters Actually Work
Each Jilter filter traps tar and combustion debris through a cellulose sponge structure containing thousands of fine pores that physically block particles as small as 5 microns. When smoke passes through, those pores act as a physical barrier — catching roughly 70% of tar particles according to independent cellulose filtration studies referenced by the EMCDDA in their harm-reduction literature. You can slot one or two filters into a single XL glass tip depending on how tight you want the draw. One filter gives a light filtration with easy airflow. Two filters tighten things up and catch more residue — you'll see the difference on the filter itself after a single smoke.
The glass tip doesn't filter anything on its own. What it does is give you a solid, heat-resistant mouthpiece that won't collapse, won't get soggy, and won't change the taste of your smoke. Borosilicate glass is inert — it adds nothing and takes nothing away. Compare that to a cardboard roach, which starts tasting like wet paper after about 3 minutes.
How to Use Jilter Filters with XL Glass Tips
Setting up a Jilter filter inside an XL glass tip takes about 10 seconds and requires no tools, adhesive, or experience beyond basic rolling skills.
- Take one XL glass tip and one Jilter filter from the pack. If you want heavier filtration, grab two filters.
- Push the Jilter filter into one end of the glass tip. It should fit snugly — the cellulose compresses slightly to create a seal. No glue, no tape.
- Roll your cigarette as you normally would, but leave roughly 1cm of space at the mouth end of the paper — this is where the glass tip slots in.
- Insert the glass tip (filter end facing inward, toward the tobacco) into the open end of your rolled cigarette. The paper should wrap around the outside of the glass.
- Light up and draw. You'll notice the smoke feels cooler and the draw is slightly tighter than an unfiltered roll.
- After smoking, pull out the used Jilter filter and bin it. Rinse the glass tip under warm water, let it dry, and it's ready for next time.
Running low on filters? The standalone Jilter Filters 42-pack gives you a refill without the glass tips. If you want a complete rolling setup, pair these with your favourite rolling papers and a decent grinder — the SLX Grinder is the one we'd reach for, since the ceramic coating means no metal shavings near your smoke. You can also buy the Jilter Rolling Machine if you prefer a consistent roll every time.
Jilter XL Glass Tips vs. Standard Glass Tips
Jilter XL glass tips are 50% wider than standard glass tips at 6mm versus roughly 4mm, making them the only glass option that matches a factory cigarette filter in diameter.
| Feature | Jilter XL Glass Tips | Standard Glass Tips |
|---|---|---|
| Diameter | 6mm | ~4mm |
| Fits standard cigarette-sized rolls | Yes | Too narrow for most |
| Compatible with Jilter filters | Yes — snug fit | Varies — often too loose |
| Feels like a factory filter | Yes | No — feels like a thin tube |
| Best for | Regular to thick rolls | Slim rolls only |
Frequently Asked Questions
How many Jilter filters come in this pack?
42 cellulose filters and 3 XL glass tips. One filter per smoke gives you 42 sessions. Double up and you get 21.
Can I reuse the Jilter cellulose filters?
No. Each filter is single-use — after one smoke it's saturated with tar and residue. The glass tips, however, are fully reusable. Rinse under warm water and they're good to go.
Do Jilter filters reduce the flavour of my smoke?
They take the edge off harsh, hot smoke — which most people experience as a cleaner taste rather than a reduced one. The glass tip itself is inert, so it adds no flavour. You lose some tar, not the taste you actually want.
What's the difference between Jilter XL glass tips and regular Jilter tips?
Diameter. The XL tips measure 6mm — same as a standard cigarette filter. Regular tips are slimmer at roughly 4mm, which suits thin rolls but feels awkward in a normal-sized cigarette. Go XL if you roll anything thicker than a slim.
How do I clean the glass tips?
Warm water and a quick rinse after each use. For a deeper clean, soak them in isopropyl alcohol for 10 minutes, then rinse thoroughly. They come out looking brand new.
Will the glass tip fall out of my rolled cigarette?
Not if you leave that 1cm gap and roll the paper snugly around the tip. The paper grips the glass. After a couple of rolls you'll get the tension right — it holds firm without being too tight to remove afterwards.
Can I use two Jilter filters at once for stronger filtration?
Yes. Stack two filters inside one XL glass tip. The draw gets tighter and the filtration is heavier — you'll see more residue on the filters. Good if you want the smoothest possible smoke, though airflow drops to about 60% of an open roach.
Last updated: April 2026
